白蚁管理 第3部分：白蚁管理系统评估标准

Australian Standard™

Termite management

Part 3: Assessment criteria for termite management systems

1

AS IS

内部资料

仅供参考

张忠辉惠存

禁止一切非法目的和活动行为，否则后果自负。

NOT FOR PUBLIC RELEASE

2

Committee BD-074, Termites

This Australian Standard was prepared by Committee BD-074, Termites. It was approved on behalf of the Council of Standards Australia on 7 December 2000 and published on 27 December 2000.

The following interests are represented on Committee BD-074:

• Australian Building Codes Board
• Australian Consumers Association
• Australian Environmental Pest Managers Association
• CSIRO Entomology
• CSIRO Forestry and Forest Products
• Cement and Concrete Association of Australia
• Clay Brick and Paver Institute
• Construction, Forestry, Mining and Energy Union
• Forest and Wood Products Research and Development Corporation
• Housing Industry Association
• Insurance Council of Australia
• Local Government and Shires Associations of New South Wales
• Master Builders Australia
• National Registration Authority for Agricultural and Veterinary Chemicals
• Queensland Forestry Research Institute
• State Forests of New South Wales
• Total Environment Centre

Keeping Standards up-to-date

Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased.

Detailed information about Standards can be found by visiting the Standards Australia web site at www.standards.com.au and looking up the relevant Standard in the on-line catalogue.

Alternatively, the printed Catalogue provides information current at 1 January each year, and the monthly magazine, The Australian Standard, has a full listing of revisions and amendments published each month.

We also welcome suggestions for improvement in our Standards, and especially encourage readers to notify us immediately of any apparent inaccuracies or ambiguities. Contact us via email at mail@standards.com.au, or write to the Chief Executive, Standards Australia International Ltd, GPO Box 5420, Sydney, NSW 2001.

This Standard was issued in draft form for comment as DR 98376.

3

Australian Standard™

Termite management

Part 3: Assessment criteria for termite management systems

First published as AS 3660.3—2000.

COPYRIGHT

© Standards Australia International

All rights are reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical, including photocopying, without the written permission of the publisher.

Published by Standards Australia International Ltd

GPO Box 5420, Sydney, NSW 2001, Australia

ISBN 0 7337 3734 X

4

PREFACE

This Standard was prepared by the Standards Australia Committee BD-074, Termites.

The objective of this Standard is to provide manufacturers, suppliers, testing organizations and approval authorities with minimum criteria, which have to be met before termite management systems can be used in and around buildings and structures.

The terms ‘normative’ and ‘informative’ have been used in this Standard to define the application of the appendix to which they apply. A ‘normative’ appendix is an integral part of a Standard, whereas an ‘informative’ appendix is only for information and guidance.

5

CONTENTS

Page

SECTION 1 SCOPE AND GENERAL

1.1 SCOPE 5

1.2 APPLICATION 5

1.3 ASSESSMENT PROVIDERS 5

1.4 NEW AND ALTERNATIVE SYSTEMS 5

1.5 REFERENCED DOCUMENTS 6

1.6 DEFINITIONS 6

SECTION 2 ASSESSMENT METHODOLOGY

2.1 SCOPE OF SECTION 8

2.2 GENERAL 8

2.3 PRELIMINARY CONSIDERATIONS 8

2.4 LABORATORY ASSESSMENTS 8

2.5 FIELD ASSESSMENTS 9

2.6 ASSESSMENT REPORT 10

SECTION 3 PHYSICAL BARRIERS

3.1 SCOPE OF SECTION 11

3.2 GENERAL 11

3.3 SYSTEM COMPONENTS 11

3.4 COMPLETE SYSTEMS 11

SECTION 4 CHEMICAL BARRIERS

4.1 SCOPE OF SECTION 13

4.2 GENERAL 13

4.3 SOIL BARRIERS 13

4.4 NON-SOIL BARRIERS 13

4.5 DISTRIBUTION SYSTEMS 14

SECTION 5 MONITORING AND AGGREGATION SYSTEMS

5.1 SCOPE OF SECTION 15

5.2 GENERAL 15

5.3 LABORATORY ASSESSMENTS 15

5.4 FIELD ASSESSMENTS 15

SECTION 6 RESISTANT MATERIALS

6.1 SCOPE OF SECTION 16

6.2 GENERAL 16

6.3 CELLULOSIC 16

6.4 NON-CELLULOSIC AND COMPOSITE 16

SECTION 7 COLONY ERADICATION

7.1 SCOPE OF SECTION 17

7.2 GENERAL 17

7.3 DETERMINING COLONY ERADICATION 17

7.4 COLONY DESTRUCTION 17

6