HG/T 2882-1997 Determination of drying performance of driers

HG/T 2882-1997 Determination of drying performance of driers HG/T2882-1997 Standard download decompression password: www.bzxz.net

Chemical Industry Standard of the People's Republic of China
HG/T2882—1997
Determination of drying power of driers1997-04-21 Issued
Ministry of Chemical Industry of the People's Republic of China
Implementation on 1997-10-01wwW.bzxz.Net
HG/T2882—1997
This standard partially changes the technical content of GB/T1744-1979 (1989) "Determination of drying power of driers" and makes comprehensive editorial revisions to it.
The difference between this standard and GB/T1744 in technical content is: the iodine value of refined linseed oil is changed from above 180 to above 175. From the date of implementation of this standard, the original GB/T1744—1979 (1989) shall be abolished. This standard is proposed by the Technical Supervision Department of the Ministry of Chemical Industry of the People's Republic of China. This standard is under the jurisdiction of the National Technical Committee for Standardization of Paints and Pigments; the drafting unit of this standard is the Changzhou Paint Chemical Research Institute of the Ministry of Chemical Industry; the drafter of this standard is Ji Xiaoman.
1 Scope
Chemical Industry Standard of the People's Republic of China
Determination of drying power of driers
Determination of drying power of driersHG/T2882—1997
This standard specifies the test method for determining the drying power of driers. Applicable to the determination of the drying power of driers. 2 Referenced standards
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest version of the following standards. GB/T1727—1992 Paint film—General preparation method GB/T1728—1979 (1989) Determination of drying time of paint film and putty film GB9278—1988 Temperature and humidity for state adjustment and test of paint samples (eqVISO3270:1984) 3 Materials and instruments
3.1 Refined linseed oil: iodine value above 175; 3.2 Glass plate 90mm×120mm×(2~3)mm 3.3 Paint brush: width 25mm~35mm;
3.4 ​​Beaker: 50mL;
3.5 Balance: sensitivity 0.01g.
4 Operating steps
4.1 According to the ratio specified in the drier standard, weigh (accurate to 0.01g) drier and refined linseed oil, mix them evenly in the beaker and let them stand for 2h~5h. According to 6.1 brush coating method in GB/T1727, prepare the coating on the glass plate and dry it under the conditions specified in GB9278.
4.2 According to the time specified in the drying agent standard, use Method B in Chapter 2 of GB/T1728 (finger touch method) and Method C in Chapter 3 (blade method) to judge the surface dryness and thorough dryness of the coating. The drying performance is expressed in h. 5 Test report
The test report shall at least include the following contents: a) Model and name of the tested product;
b) Indicate the adoption of this industry standard;
c) Any differences from the contents specified in this standard d) Test results;
e) Test date.
Approved by the Ministry of Chemical Industry of the People's Republic of China on April 21, 1997 and implemented on October 1, 1997
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.