YS/T 455.5-2003 Test methods for aluminium foil Part 5 Test method for DC resistance of aluminium foil

This standard specifies the DC resistance test method for aluminum foil. This method is applicable to the DC resistance test of standard samples of aluminum foil for power and radio capacitors at 20°C. YS/T 455.5-2003 Aluminum foil test method Part 5 DC resistance test method for aluminum foil YS/T455.5-2003 Standard download decompression password: www.bzxz.net

F5/T455.5—2003
The test method series standard is designed based on 875—05 industrial pure alcohol standard, and is designed based on 8.4STMH479:2Hi0 soft packaging protective layer lead and intelligent alloy 3 standards.
This standard is the first standard in the series of relevant test method standards. The series of standards include the following parts: ST45.1-34 braid test method YS/T55.2-20036 shrinkage test method
YS/T45.3-2M36 clamp box test method lead acid test method YST45.1-20030 key drop test method potential box water test method 215/455.5-00 foil test method instrument standard free resistance test method YS/T435.5-2X3S box test method total box other related test methods This standard is proposed by the National Nonferrous Metals Standardization Technical Committee and is under the jurisdiction of the National Nonferrous Metals Standardization Technical Committee. Wood Standard North China Science and Technology Co., Ltd. This standard mainly includes the following aspects: avoidance of the material, the material ... 3. Sample preparation
3.1 The test sample is 25m long and 25m wide. Two test samples should be drawn and their actual width should be measured at least twice/each, and the average value should be taken.
3.2 According to the resistance law, the standard sample resistance should be 1 times the test sample resistance. 4 Determination method
4.1 Estimation of resistance value
According to the law, the resistance of the test sample is calculated (for example, the thickness of the pure pin box is 307mm, and the selected test sample resistance value is approximately,
4.2 Measurement Fixed width temperature electric
Put the test sample on the fixture, put it in phase, m, and take the proportional bridge as 10. Record the reading of the double kidney bridge (fine-tune it with the rear resistance value of the test sample) R and record the room temperature at that time. Measure each sample once and take its half-average R..
4.3 Calculate the standard sample resistance at 20℃
Where,
The resistance of the test sample at ", in ohms; standard resistance value, R=G.501R:
Proportional correction, R,=10 2,
The average value of the double-passion electric selection band, in ohms (Q) Width correction factor: Www.bzxZ.net
Delay correction factor, =+a(20-, where is the resistance temperature change coefficient: =heart 4. Standard sample resistance value 18XR11××
R×RxX*X1
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.