QB/T 2287-1997 Nail polish

This standard specifies the technical requirements, test methods, inspection rules and requirements for marking, packaging, transportation and storage of nail polish. This standard applies to a viscous liquid used for nail polish. QB/T 2287-1997 Nail Polish QB/T2287-1997 Standard download decompression password: www.bzxz.net

QB/T2287—1997
This standard is revised from ZBY42007-1989 "Nail Polish". The main revisions are as follows: It is compiled in accordance with GB/T1.1-1993 "Guidelines for Standardization Work Unit 1: Rules for Drafting and Presentation of Standards Part 1: Basic Regulations for Standard Compilation";
—The relevant parts use the method of citing QB/T1684—1993 "Cosmetics Inspection Rules" and QB/T1685-1993 "Appearance Requirements for Cosmetic Product Packaging" to replace the original technical content; the original technical indicator "dryness" is renamed "drying time", and the viscosity and its test method in the original standard are cancelled; the net content indicator and test method are implemented in accordance with the National Technical Supervision Order [19953 No. 43 "Measurement Supervision Regulations for Quantitative Packaged Goods". This standard is proposed by the Quality Standards Department of China Light Industry Federation. This standard is under the jurisdiction of the National Cosmetics Standardization Center. The drafting unit of this standard: Shanghai Jahwa Co., Ltd. The main drafters of this standard: Wang Hanzhou, Zhigang, Chen Yafang. As of the date of implementation of this standard, the professional standard ZBY42007-1989 "Nail Polish" issued by the former Ministry of Light Industry shall be invalid. 246
Light Industry Industry Standard of the People's Republic of China
Nail Polish
QB/T 2287—1997
This standard specifies the technical requirements, test methods, inspection rules and requirements for marking, packaging, transportation, storage, etc. of nail polish. This standard applies to a viscous liquid used for modifying cosmetic nails. 2 Referenced Standards
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB7916-1987 Hygienic Standard for Cosmetics
GB5296.3—1995 Instructions for Use of Consumer Products General Labeling for Cosmetics
QB/T1685—1993 Requirements for the Appearance of Cosmetic Product Packaging QB/T 1684--1993
3 Product Classification
Cosmetic Inspection Rules
Nail polish can be divided into transparent nail polish, colored nail polish and other specifications according to the product. Technical Requirements
The content of toxic substances Hg, As and Pb in the product shall comply with the requirements of GB7916. Physical indicators shall comply with the provisions of Table 1.
Indicator Name
Drying time, min
Firmness
Tolerance of Net Content, g (mL)
(Average of 10 bottles)
4.2 Requirements for Packaging Appearance
According to QB/T1685.
5 Test method
5.1 Color
Sampling is visually inspected at room temperature and not under direct sunlight. 5.2 Drying time
5.2.1 Reagents and instruments
Approved by China Light Industry Association on April 10, 1997
TKAONKAca-
Conforms to enterprise regulations
No shedding
≤10.±1
>10,±2
Implemented on December 1, 1997
a) Ethyl acetate (chemically pure),
b) Thermometer: graduation value, 0.2℃,
QB/T 2287-- 1997
c) Slide: 75.5mm×25.5mm×1.2mm, d) Stopwatch.
5. 2. 2 StepsbzxZ.net
At room temperature (20±5℃), clean the slide with ethyl acetate. After drying, use a brush to apply the nail polish sample on the slide at one time. Press the stopwatch immediately. After 10 minutes, touch it with your hand to see if it is dry. 5.3 Fastness
5.3.1 Reagents and instruments
a) Ethyl acetate (chemically pure),
b) Thermometer: graduation value, 0.2℃,
c) Slide: 75.5mm×25.5mm×1.2mm; d) Stainless steel ruler
e) Embroidery needle: No. 9 long.
5.3.2 Steps
At room temperature (20±5℃), clean the slide with ethyl acetate. After drying, use a brush to apply a layer of nail polish sample on the slide. After leaving it for 24 hours, use an embroidery needle to make five horizontal and vertical cross lines, each with a spacing of 1 mm. Observe that there should be no squares falling off. 5.4 Net content tolerance
5.4.1 Operation method
Take 10 bottles of samples, weigh their gross weight, then remove the contents, wash with ethyl acetate (chemically pure) and dry, and then weigh their tare weight. 5.4.2 Net content tolerance is calculated according to formula (1). In the formula: △Q-
-Net content tolerance of the sample, g:
Q. --Net content of the sample marked, g,
Q,-Actual net content of the sample? g,
Number of samples: 10.
Milliliter determination is converted to density (25℃): or calculated by water volume. 5.5 Packaging appearance
According to QB/T1685.
6 Inspection rules
According to QB/T1684.
7 Marking, packaging, transportation, storage
7.1 Marking
7.1.1 Large and medium packaging certificate marking
According to 3.9.5, 3.10.2.3, 3.10.3.3 of QB/T1685. 7.1.2 Sales packaging marking
According to GB5296.3.
7.2 Packaging
The finished product is packed in medium packaging, and the box head label should be affixed. The large packaging should be packed solidly without gaps, the box should be sealed and packed firmly, and there should be a certificate of conformity. 248
（1）
7.3 Transportation
QB/T2287--1997
Must be placed and unloaded with care, and stacked according to the arrow marks on the boxes to avoid severe vibration, impact, sun and rain. 7.4 Storage
Should be stored in a ventilated and dry warehouse with a temperature not higher than 35℃, and should not be close to stoves and heaters. When storing, it must be 20cm away from the ground and 50cm away from the inner wall. There should be a ventilation duct in the middle, and the first-in-first-out principle should be followed. 249
iiikAoNikAca-
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.