JB/T 8602-1997 Vertical tapping machine accuracy inspection

JB/T 8602-1997 This standard specifies the requirements and methods for the precision inspection and working precision inspection of vertical tapping machines. This standard applies to general-purpose ordinary precision vertical tapping machines with a maximum tapping diameter of M24. JB/T 8602-1997 Vertical tapping machine precision inspection JB/T8602-1997 standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
35/T8602-1997
Vertical Tapping Machine
Published on 1997-08-18
Precision Inspection
Implementation on 1998·0]01
Ministry of Machinery Industry of the People's Republic of China
JB/I8602-1997
This standard is provided by the Technical Committee for Standardization of Cutting Machine Tools of Jinguo Jinman, and this standard is not limited to Shenyang Drilling and Light Machine Tool Research Institute! , This standard was drafted by: Haining Machine Tool Factory
1 Scope
Machinery Industry Standard of the People's Republic of China
Vertical Tapping Machine Precision Inspection
The standard card corrects the requirements for the vertical tapping machine to be inspected and inspected gradually, and the standard is applicable to the vertical tapping machine with a maximum wire diameter of M24. 2 Reference Standards
JB/T86121997
The texts contained in the standard are recorded below, and the provisions that constitute the market standard are clearly stated in the standard. The version shown here is valid. All standards will be revised and used by all parties to the standard to explore the technical capabilities of the new version. (3197-3)
LB/T$6892
When the thread effect tolerance is matched (diameter 1-35513.) thread tolerance
Gn/T163-1905 surface roughness parameters and their numerical pins GB2570-82
1B/2258-85
3 face requirements
Quality cutting machine flow epidemic adjustment general rules
Drill flat before changing the thread. Use water drill diameter
3.! But when using the standard, the adjustment shall follow the relevant provisions of JB2?C. The amount of surprise depends on the previous installation plan 1 and other parts of the air permeability temperature change, pick up the test method and test two on the right
3.2 black JB3670-82 3.1 adjust the installation level, put the fire on the working surface level ruler, the water meter in the weaving direction and the inspection direction of the reading efficiency shall not exceed 0.10/000.
3.3 During the inspection, the general Sichuan control transfer inspection: the original and number signatures are convenient for arranging the actual comprehensive position and optimal sequence. 3.4\ When the actual measured length is different from the length specified in this standard, it should be converted according to the length that can be measured by the existing technology in 2.3.1.1 of Beijing 267℃82. When the converted result is less than .m, it should be calculated. 3.5 The operating plane referred to in this standard refers to the true plane passing through the main axle load and the axle point, which can be the vertical plane or the horizontal plane passing through the side average line.
3.6 The length is designed by the user manufacturer, and the calibration items can be reduced. Machinery City Industry Department 19781 approved
199811 implementation
8602-1997
032523
8602-1997
OOE/CT
301/90
IB/T 8602·1997
JB/T 602—1907
(TEO/)
261 99) wwW.bzxz.Net
Same as 9
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.