JB/T 3411.50-1999 Dimensions of two-claw pullers

JB/T3411.50-1999 This standard is a revision of JB 3460-83 "Dimensions of two-claw pullers". During the revision, only the following points were modified, and the main technical content remained unchanged: - Writing format; - Standard name plus English; - Thread drawing method. This standard specifies the type and size of two-claw pullers. JB/T 3411.50-1999 Dimensions of two-claw pullers JB/T3411.50-1999 Standard download decompression password: www.bzxz.net

ICS25.100.40
Machinery Industry Standard of the People's Republic of China
JB/T3411.50-1999
Two jaws thruster
Two jaws thruster Dimensions
Issued on 1999-05-20
State Bureau of Machinery Industry
Implementation on 2000-01-01
1 Scope
Machinery Industry Standard of the People's Republic of China
Two jaws thruster
Two jaws thruster Dimensions
This standard specifies the types and dimensions of two jaws thrusters. 2 Type and size
Type and size are as specified in the following figure and table
Marking example:
HF-160mm two-claw puller:
Puller
JB/T3411.50—1999
National Machinery Industry Bureau approved JB/T3411.50-1999 on May 20, 1999
Replaced JB346083bzxz.net
2000-01-01implemented
Mechanical industry standard
Two-claw puller||tt| |JB/T3411.50—1999
Published by the Machinery Standardization Research Institute of the Ministry of Machinery Industry Printed by the Machinery Standardization Research Institute of the Ministry of Machinery Industry (No. 2 Shouti South Road, Beijing: Postal Code 100044)*
Format 880×1230
X Number of characters xXX,XXX
Print sheets X/X
Xth printing in XX month, 19XX
Xth edition in XX month, 19XX
Number of prints 1-XXX
Price XXXX Yuan
XX-XXX
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.