GB/T 4211.1-2004 High speed steel turning blades Part 1: Types and dimensions

This part is equivalent to ISO5421:1977 "Ground high-speed steel turning blades". GB/T 4211.1-2004 High-speed steel turning blades Part 1: Types and dimensions GB/T4211.1-2004 Standard download decompression password: www.bzxz.net

TCS 25. 10D.10
National Standard of the People's Republic of China
GB/T 4211.1—2004/ISO 5421:1977
High speed steel turning tool blades Part 1: Types and dimensions (Is0 3421:1977, for round high $peed xleel kol its, 1Dr) Issued on February 10, 2004bzxz.net
General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China
Implementation on August 1, 2004
/211 High speed turning tool blades are divided into two parts,
Part 1: Types and dimensions;
Part 2: Technical requirements.
This part is the first part of GB4211.
GB/T4211.1—2004/I505421:1977 This part adopts 150, 421:15778 ground high-performance steel. This part is divided into English version (3): For ease of use, this part makes the following modifications: "This international standard" is changed to "≥" in the part, "recommended as the number of the small effective point", ": Drawings are made according to Chinese standards:
Delete the words of the international standard:
Add the material appendix "normal pressure dimensions". This part replaces (B/T121) 19844 high-performance steel car type and size before: This part is compared with: 11/14211-198. The overall changes are as follows: The following technical requirements are listed in Part 2 Technical Conditions: The test method part of (H311-184) and the marking and packaging part are included in the technical clauses: The acceptance chapter is cancelled!
The marking examples are cancelled;
Dimensions not in 3121:37 are listed as common sizes in Appendix A, and the informative Appendix A\Common Dimensions\Part 6 of the Yin-Yang Record A is added as an informative appendix.
The Ministry of Industry and Information Technology and the Ministry of Commerce have jointly issued this part of the drafting unit of this part: the Ministry of Tools and Equipment Research Institute. The main drafters of this part are: Yue, Check and. This part of the standard is the first release of the evaluation identification: (H/T 4711382.
1 Scope
High speed steel turning tool strips
t+R/T 4211.1—2004/ISD 5421:1977 Part 1 Types and dimensions
This part specifies the types and dimensions of the following commercial steel turning strips: Shaped surface (Second Section):
Square cross section (Second Section):
Rectangular cross section (First ... 5421:1977h
Rectangular disc turning tool
Unit is meter
neutral
Second type
Irregular quadrilateral turning tool (cutting tool with side angle but no back angle) 5
: After discussion between supply and demand, one end of this turning tool can be made into an angle, 82
CH/T4211.1—2004/E505421:1977Unit is millimeter
GB/F4211.1—2004/18( 5421,1977A.1 Square
Jiang: The ones with brackets and as small as possible.
Appendix A
(Informative Appendix)
Common Sizes
Table A, 1
Unit is the price
Single business is the old technology
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.