YS/T 455.3-2003 Aluminium foil test methods Part 3 Aluminium foil adhesion test method

This part specifies the test method for the adhesion of aluminum foil. This method is suitable for detecting the adhesion between aluminum foil layers. YS/T 455.3-2003 Aluminum foil test method Part 3 Aluminum foil adhesion test method YS/T455.3-2003 Standard download decompression password: www.bzxz.net

YS/T455.32003
Aluminum micro-test method series standard is formulated on the basis of the requirements of the industrial pure aluminum standard (1981996~.1), with reference to 516.1159?Frame modification and sales of Taiwan Metallurgical Consumption 2[503758:1383: Determination of bursting strength 2A5M47S:2000 soft packaging shelf life and male alloy treatment 3 and other standards.
This standard is the third standard in the series of standards "lead foil test method", and the system test standards include the following six parts; 5/455.12003 aluminum box test method key cat surface lubrication tension test drive method 3YS/T455.2:2003 aluminum box test Ridge method
Aluminum box hole counting detection method
YS/T153.4—3003 Aluminum shrinkage test method Aluminum block analysis and attachment test method YS/14572—20056 Aluminum box other test methods
Book foil brush water test method3
YS/T455.520038 Aluminum section test piece method
Self-flowing industry resistance method for pin box
YS/T455.62003 Pin box test method
Aluminum box other related test methods3
This standard is proposed by the National Metal Standardization Technical Committee, and this standard is issued by the National Nonferrous Metals Standardization Technical Committee This standard is issued by North China Aluminum Co., Ltd. Wu Yuedan, the main drafters of the standard are: Ju Minggu, Kong Yangyou, Xia Chaosujie, Xie Xuebie, Zhang Shengao Jinghuan. This standard is interpreted by the National Technical Committee for Standardization of Nonferrous Metals 1 Specification
Aluminum foil test method
Part 3 Aluminum foil adhesion test method
Part 3 specifies the adhesion test method of aluminum foil. This method uses the flow measurement of the adhesion between the treatment layer and the layer 2 Method principle
YS/T455.3—2003 bzxz.net
This method determines the minimum separation length required for the natural expansion of the low-weight aluminum foil to determine the fine removal of the aluminum foil between the layers. 3. Test for turbulence
The test is carried out at room temperature. Before the test, the outer layer of 1rm~mm is removed. 4. Test method
4.1 Lead coil through the axis: After the bubble is formed, the coil is level with the ground. 4.2 The outer layer of aluminum is artificially unfolded along the coiling direction. And the unfolding shape is shown in Figure 1 (()A. ()A is the horizontal line through the axis). When the full length of the sag is exceeded, the pin box is naturally opened to the fixed white in the natural unfolding. The required minimum is the sag length. When the required length is longer, for the convenience of operation, the box will be folded and the final unfolding length is measured.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.