JB/T 3411.106-1999 7:24 Dimensions of short Morse taper intermediate sleeves for taper/forced transmission

JB/T 3411.106-1999 This standard is a revision of JB 3517-83 "7:24 Taper/Morse Taper Short Intermediate Sleeve Dimensions for Forced Transmission". Only the following points were modified during the revision, and the main technical content remained unchanged: - Writing format; - Standard name plus English; - Relevant reference standards and related content; - Thread drawing method. This standard specifies the type and size of 7:24 Taper/Morse Taper Short Intermediate Sleeve for Forced Transmission. JB/T 3411.106-1999 7:24 Taper/Morse Taper Short Intermediate Sleeve Dimensions for Forced Transmission JB/T3411.106-1999 Standard download decompression password: www.bzxz.net

IC5 25.00.01
Mechanical Industry Standard of the People's Republic of China
IB/T 3411.101-3411.127—1999 Accessories for milling machines
Accessories afmilling maclhincs1999-05-2U Issued by
National Machinery Industry Bureau
Implementation on 2000-01-01
Mechanical Industry Standard of the People's Republic of China
7:24 taper/forced transmissionbzxZ.net
Morse taper short intermediate sleeve
Shorte hanging diameter bush with7:24 laperipasitive maste per-Dlalensions This standard specifies the unique dimensions of the Morse taper type intermediate sleeve with 24 forced transmission. 2 Reference standards
JB/T3411.106—1999
with JR3517-81
The following standards contain the following clauses: The clauses inscribed in the following standards are used in this standard and constitute the clauses of this standard. When this standard is published, the editions shown are valid. All standards are subject to revision. Parties using this standard should consider the possibility of using the latest editions of the following standards: GB.T 3B37.3—1983
GB.T 4133—1984
JD/T 3411.1251999
Types and dimensions
7·24 Circular-connected two-way chain handle
Forced transmission type of milling machine
Drawbar size
Types and dimensions are determined according to the table of production.
1724 Figure
Free tie rod
JE/T3411.1
Figure Approved by National Machinery Industry Bureau on 1999-0-20 Implemented on 2000-01-01
Thank you number
JB/T3411.106—1999
【7:24 The dimensions and deviations of the purchased items shall be in accordance with the dimensions and deviations specified in GD/T3837.3. The old 4 door 3 sees the specified 4 markings
Marking example:
Basic +
Calibration limit deviation
The outside is 7:2450, the chain bottle transmission is the long network hungry 4? : 24-tone transmission of the West Middle Meal 50-4B/T3411.106—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.