JB/T 8021.2-1999 Machine tool fixture parts and components - Bolt-type positioners

JB/T 8021.2-1999 This standard is a revision of JB/T 8021.2-95 "Bolt-type positioners for machine tool fixture parts and components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies bolt-type positioners with specifications of 12~18mm. This standard was first issued in 1981 as GB 2216-80, first revised to GB/T 2216-91 on April 30, 1991, and adjusted to JB/T 8021.2-95 in April 1996. JB/T 8021.2-1999 Bolt-type positioners for machine tool fixture parts and components JB/T8021.2-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixturesRifle bolt locator
This standard specifies the bolt locator with a specification of 12~18mm. 2 Dimensions
The dimensions are shown in the following figure and table.
National Machinery Industry Bureau approved JB/T8021.2-1999 on August 6, 1999
Replaced JB/T8021.2-1995bzxz.net
Implemented on January 1, 2000
3 Marking
Marking example:
d-12mm bolt-check locator:
Locator
12JB/T8021.2-1999
JB/T8021.2-1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.