JB/T 10338-2002 Magnetic particle inspection procedure for rolling bearing parts

This standard specifies the procedures for wet magnetic particle testing of rolling bearing parts. JB/T 10338-2002 Regulations for magnetic particle testing of rolling bearing parts JB/T10338-2002 Standard download decompression password: www.bzxz.net

ICS21.1Q0.20
Machinery Industry Standard of the People's Republic of China
JB/T10338—2002
Specializations for imagnetic particle flaw detection of rolling bearing parls2002-07-16 issued
2002-12-01 implementation
The State Economic and Trade Commission of the People's Republic of China issued before.
Normative reference documents
Terms and definitions, symbols,
Qualification of deeply injured personnel..
Number of rescue equipment and instruments
Magnetic content detection cold rolling
5.2 Avoiding secrets
5.4 Piece war test block
Detection section
Magnetization method
Backward magnetization
Cross-densification
Re-magnetization
8 Magnetization specification
8.1 Original direction magnetization compliance.
$.2 Longitudinal magnetization specification
8.3 Inductive current cloud magnetization specification grab
10 Detection potential record.
1 Magnetization specification by electric current
Table 2 Core rod diameter and minimum number of eccentric magnetization points
JB/T1033B—2002Www.bzxZ.net
This standard is proposed by China Machinery Industry Federation. Foreword
This standard is the responsibility of China National Standardization Technical Committee (CSBTS) 1JEIT1033B-2002
This standard is drafted by Bailuo Bearing Research Institute, Nanjing Dongdian Machinery Factory, Geyang Bearing Group Co., Ltd., Wafangdian Bearing Co., Ltd., and Harbin Real Vehicle Group Co., Ltd. The editors of this standard are: Lei Jianzhong, Gao An, Hua Liantai, Zeng Weiwen, Zhang Kuidi, Zhang Zhengqi, and this Pumin. II
1 Scope
Regulations for magnetic particle inspection of rolling bearing parts
Not specified This article specifies the regulations for magnetic particle inspection of rolling bearing parts (hereinafter referred to as “magnetic particle inspection”). JB/T10338—2002
This standard applies to the magnetic flaw detection of surface and near-surface defects of bearing parts (including flying, semi-finished products, finished products and parts under repair) made of ferromagnetic materials:
2 Normative references
The clauses in the following documents are the clauses of this standard through reference in this standard. For all referenced documents with a date, all subsequent revisions, excluding the contents with lapses or revised versions, are not applicable to this standard. However, the parties who reach an agreement on the revision of this standard are encouraged to study whether the latest versions of these documents can be used. For all referenced documents without a date, the latest versions shall not be applied to this standard. 0B/T9445—1999 Qualification and certification of optical fiber inspection personnel (idt509712: T992) G/T12604.51990 Nondestructive testing, magnetic particle inspection 5/16063—1992 Technical conditions for the use of magnetic particle inspection as powder
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.