JB/T 8010.9-1999 Machine tool fixture parts and components flat plate

JB/T 8010.9-1999 This standard is a revision of JB/T 8010.9-95 "Machine Tool Fixture Parts and Components Flat Plates". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies flat plates applicable to thread specifications of M6 to M36. This standard was first issued in 1981 as GB 2183-80, first revised to GB/T 2183-91 on April 30, 1991, and adjusted to JB/T 8010.9-95 in April 1996. JB/T 8010.9-1999 Machine Tool Fixture Parts and Components Flat Plates JB/T8010.9-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixturesWww.bzxZ.net
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Parts and components of jigs and fixtures
Flat clamp plate
The parts and units of jigs and fixturesFlat clamp plate
This standard specifies the flat clamp plate applicable to thread specifications of M6 to M36. 2 Referenced standards
JB/T8010.9-1999
Replaces JB/T8010.9—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T699—1988
Technical conditions for high-quality carbon structural steel
JB/T8044—1999Technical requirements for machine tool fixture parts and components3 Dimensions
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999B
Implementation on January 1, 2000
Nominal diameter
(thread diameter)
4 Technical conditions
4.1 Material: 45 steel in accordance with the provisions of GB/T699. 4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions in accordance with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
JB/T8010.91999
A-type flat plate with nominal diameter = 20mm and L = 200mm: Platen A20×200JB/T8010.9—199986
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.