GB/T 4095-1995 Dimensions for installation of spoke-type wheels on truck hubs

This standard specifies the installation dimensions of truck wheels when they are centered on the wheel hub in different ways. This standard applies to truck spoke-type wheels with 5, 6, 8 and 10 bolt holes. GB/T 4095-1995 Installation dimensions of truck spoke-type wheels on the wheel hub GB/T4095-1995 Standard download decompression password: www.bzxz.net

National Standard of the People's Republic of China
Disc wheels for trucks
Dimensionaj characteristics of attachment on hubGB/T4095—1995
Replaces GB4095--83
This standard adopts the international standard ISO4107 "Road vehicles-Commercial vehicle wheels-Dimensions of attachment on hub". 1 Subject content and scope of application
This standard specifies the installation dimensions of truck wheels when centered on the hub in different ways. This standard is applicable to truck disc wheels with 5, 6, 8 and 10 bolt holes. 2 Installation dimensions
2.1 The installation dimensions of the wheel when centered by the center hole shall comply with the provisions of Figure 1 and Table 1. To circle
Approved by the State Bureau of Technical Supervision on September 12, 199578
Implementation on March 1, 1996
Number of bolt holes
Distribution diameter of bolt holes
Bolt holes
Position
GB/T4095-1995
Bolt holes
Wheel installation method with center hole as the recommended method Center hole
D, +g?
Spoke plane
Partial diameter
2.2 The wheel installation dimensions when centered by the nut seat shall comply with the requirements of Figure 2 and Table 2. Figure 2
Bolt diameter
Reference scale
Number of bolt holes
Nut seat division
Circle diameterbzxz.net
Additional instructions:
Nut seat
Position accuracy
GB/T4095--1995
Continued Figure 2
Bolt hole
Spherical radius
This standard was proposed by China National Automotive Industry Corporation and is under the jurisdiction of the National Technical Committee for Automotive Standardization. This standard was drafted by the Wheel Factory of Dongfeng Motor Corporation. The main drafter of this standard is Li Hongxing.
Center hole
Spoke plane
Partial diameter
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.