滚动轴承——动态载荷额定值和额定寿命

AS 2729—1994

ISO 281:1990

Australian Standard®

Rolling bearings—Dynamic load ratings and rating life

1

AS IS

内部资料

仅供参考

张忠辉惠存

禁止一切非法目的和活动行为，否则后果自负。

NOT FOR PUBLIC RELEASE

2

Foreword

This Australian Standard was prepared by Committee ME/37, Rolling Bearings. It was approved on behalf of the Council of Standards Australia on 28 October 1993 and published on 21 March 1994.

The following interests are represented on Committee ME/37:

• Australian Chamber of Commerce and Industry
• Federation of Automotive Products Manufacturers
• Institution of Engineers Australia
• Metal Trades Industry Association of Australia
• Railways of Australia Committee
• Society of Automotive Engineers—Australasia

Review of Australian Standards. To keep abreast of progress in industry, Australian Standards are subject to periodic review and are kept up to date by the issue of amendments or new editions as necessary. It is important therefore that Standards users ensure that they are in possession of the latest edition, and any amendments thereto.

Full details of all Australian Standards and related publications will be found in the Standards Australia Catalogue of Publications; this information is supplemented each month by the magazine 'The Australian Standard', which subscribing members receive, and which gives details of new publications, new editions and amendments, and of withdrawn Standards.

Suggestions for improvements to Australian Standards, addressed to the head office of Standards Australia, are welcomed. Notification of any inaccuracy or ambiguity found in an Australian Standard should be made without delay in order that the matter may be investigated and appropriate action taken.

3

Australian Standard^®

Rolling bearings—Dynamic load ratings and rating life

First published as AS 2729—1984. Second edition 1994.

PUBLISHED BY STANDARDS AUSTRALIA (STANDARDS ASSOCIATION OF AUSTRALIA) 1 THE CRESCENT, HOMEBUSH, NSW 2140

ISBN 0 7262 8743 1

4

PREFACE

This Standard was prepared by the Standards Australia Committee on Rolling Bearings to supersede AS 2729—1984, Rolling Bearings—Dynamic load ratings and rating life— Calculation method. It is identical with and has been reproduced from ISO 281:1990, Rolling bearings—Dynamic load ratings and rating life.

Under arrangements made between Standards Australia and the international Standards bodies, ISO and IEC, as well as certain other Standards organizations, users of this Australian Standard are advised of the following:

(a) Copyright is vested in Standards Australia.

(b) The number of this Standard is not reproduced on each page; its identity is shown only on the cover and title pages.

Statements expressed in mandatory terms in notes to tables are deemed to be requirements of this Standard.

For the purposes of this Australian Standard, the ISO text should be modified as follows:

(i) Decimal marker Substitute a full point for a comma as a decimal marker.

(ii) References Replace references to other publications by references to Australian Standards as follows:

5

iii

CONTENTS

(PAGE iv IN THE HARD COPY IS BLANK.)